Weatherstrip Replacement (Coupe and Convertible)

Weatherstrip Replacement (Coupe and Convertible)

Removal Procedure





1. Open the driver and passenger side doors.
2. Remove the roof lift off panel (coupe) or lower the top (convertible).




3. Remove the push in retainers from the lower corners of the weatherstrip.
4. Remove the upper LH/RH corner screws from the weatherstrip.




5. Peel the rear edge of the weatherstrip forward to expose the windshield upper retainer screws.
6. Remove the upper retainer screws.
7. Remove the weatherstrip with upper retainer.
8. Clean the surface of old sealant material.



Installation Procedure





1. Apply a bead of sealant GM P/N 12345097, or equivalent, on the windshield header from 75 mm (3 in) beyond the latches to the corner of the header.
2. Install a glob of sealant across the top of the side retainers.




3. Position the weatherstrip on the windshield frame.

Notice: Refer to Fastener Notice in Cautions and Notices.

4. Install the windshield weatherstrip upper retainer center screw.

Tighten the weatherstrip upper retainer center screw to 3.4 N.m (30 lb in).

5. Reinstall the weatherstrip to the upper retainer center.
6. Peel the weatherstrip from the upper retainer, working from the outer corner inward, in order to expose the remaining screw holes.
7. Install the following upper retainer screws:

* The LH outer and middle screw
* The RH outer and middle screw

Tighten the windshield upper weatherstrip retainer screws to 3.4 N.m (30 lb in).


8. Insert the weatherstrip into the upper retainer starting in the center and working outwards.




9. Peel the protective film from the foam tape on the sides of the new weatherstrip, or install two sided tape to the sides of a reused weatherstrip.
10. Insert the weatherstrip into the side retainer starting at the top and working downward on the LH and RH sides.
11. Install the LH and RH top corner weatherstrip screws.

Tighten the windshield weatherstrip top corner screws to 3.4 N.m (30 lb in).

12. Install the lower LH and RH corner push in retainers.




13. Install the roof panel (coupe) or raise the top (convertible).