Operation CHARM: Car repair manuals for everyone.

Coolant Heater Replacement



Coolant Heater Replacement

Removal Procedure




1. Drain the cooling system. Refer to Draining and Filling Cooling System (GE 47716) Draining and Filling Cooling System (Static Fill).
2. Remove the tire and wheel, if necessary.
3. Disconnect the engine coolant heater cord from the engine coolant heater.





Important: Take care not to damage the surface of the opening in the engine block.

4. Remove the engine coolant heater.
5. Clean the opening in the engine block, remove any burrs, sealing compound, or paint.

Installation Procedure

Important: The engine coolant heater sealing washer may be reused if not bent, scored or otherwise damaged.




1. Apply a 3.175 mm (0.125 in) bead of sealant GM P/N 12346004 (Canadian P/N 10953480) or equivalent to the engine coolant heater sealing washer.
2. Insert the engine coolant heater.

Notice: Refer to Fastener Notice in Service Precautions.

3. Tighten the engine coolant heater.

Tighten the engine coolant heater to 40 N.m (30 lb ft).




4. Install the engine coolant heater cord to the engine coolant heater.
5. Install the tire and wheel, if necessary.
6. Fill the cooling system. Refer to Draining and Filling Cooling System (GE 47716) Draining and Filling Cooling System (Static Fill).