Oil Tank Inlet Hose Replacement

Oil Tank Inlet Hose Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Drain the engine oil.
3. Remove the right front wheelhouse rear liner.
4. Remove the oil inlet/outlet hose bracket bolt.





Important: Anytime the oil tank inlet and outlet hoses are serviced, the oil seals must be replaced.

5. Remove the inlet hose to oil tank bolt (3) and disconnect the hose (2) from the oil tank. Discard the oil seal (1).




6. Remove the inlet hose to oil pan bolt (3) and disconnect the hose (2) from the oil pan. Discard the oil seal (1).
7. Remove the oil inlet hose.

Installation Procedure

1. Position the oil inlet hose.

Notice: Refer to Fastener Notice.

2. Install the oil inlet/outlet hose bracket bolt.

Tighten the oil inlet/outlet hose bracket bolt to 22 N.m (16 lb ft).




3. Using a new oil seal (1) install the oil inlet hose (2) and bolt (3) to the oil pan.

Tighten the inlet hose to oil pan bolt to 22 N.m (16 lb ft).




4. Using a new oil seal (1) install the oil inlet hose (2) and bolt (3) to the oil tank.

Tighten the inlet hose to oil tank bolt to 22 N.m (16 lb ft).

5. Install the right front wheelhouse rear liner.
6. Lower the vehicle.
7. Change the engine oil.