Compressor Hose Assembly Replacement

Compressor Hose Assembly Replacement

Tools Required

J 39400-A Halogen Leak Detector

Removal Procedure

1. Recover the refrigerant from the A/C system. Refer to Refrigerant Recovery and Recharging.
2. Remove the radiator support.

Important: Prior to removal, take note of the A/C compressor hose assembly routing and orientation between the compressor and condenser.

Cap or tape off the open A/C components immediately to prevent system contamination.




3. Remove the A/C compressor hose assembly bolt from the A/C condenser fitting.
4. Disconnect the A/C compressor hose assembly from the A/C condenser fitting.
5. Remove and discard the sealing washer.
6. Cap or tape off the A/C condenser fitting.




7. Disconnect and remove the A/C tube connector from the evaporator outlet tube and A/C compressor hose assembly.




8. Disconnect the evaporator outlet tube from the A/C compressor hose assembly.
9. Cap or tape off the evaporator outlet tube.
10. Raise and support the vehicle. Refer to Vehicle Lifting.
11. Remove the right front tire and wheel assembly from the vehicle.




12. For the 7.0L only, remove the compressor mounting bolts and nuts and lower the compressor. Refer to Compressor Replacement.
13. Remove the A/C compressor hose assembly to A/C compressor retaining bolt.
14. Disconnect the A/C compressor hose assembly from the A/C compressor.
15. Remove and discard the sealing washers.
16. Cap or tape off the A/C compressor.
17. Remove the A/C compressor hose assembly from the vehicle.

Installation Procedure

1. Install the A/C compressor hose assembly to the vehicle.




2. Remove cap or tape from the A/C compressor.
3. Install new sealing washers onto the compressor hose assembly.
4. Connect the A/C compressor hose assembly to the A/C compressor.

Notice: Refer to Fastener Notice.

5. Install the A/C compressor hose assembly to A/C compressor retaining bolt.

Tighten the bolt to 20 N.m (15 lb ft).

6. For the 7.0L only, reposition the compressor and install the bolts and nuts. Refer to Compressor Replacement.
7. Install the right front tire and wheel assembly to the vehicle.
8. Lower the vehicle.




9. Remove cap or tape from the evaporator outlet tube.
10. Install a new O-rings onto the evaporator outlet tube.
11. Connect the evaporator outlet tube to the A/C compressor hose assembly.
12. Install the A/C tube connector to the evaporator outlet tube and A/C compressor hose assembly.




13. Remove cap or tape from the A/C condenser fitting.
14. Install a new sealing washer onto the compressor hose assembly.
15. Connect the A/C compressor hose assembly to the A/C condenser fitting.
16. Install the A/C compressor hose assembly bolt to the A/C condenser fitting.

Tighten the bolt to 16 N.m (12 lb ft).

17. Install the radiator support.
18. Recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
19. Leak test the fittings of the component using J 39400-A.