Power Steering Pressure Pipe/Hose Replacement

Power Steering Pressure Pipe/Hose Replacement

Removal Procedure




1. Remove the power steering pump pulley.
2. Remove the power steering pressure hose (2) from the power steering pump (1).
3. Remove the power steering pressure hose (2) from the power steering gear.
4. Remove the power steering pressure hose (2) from the vehicle.

Installation Procedure




1. Install the power steering pressure hose (2) to the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the power steering pressure hose (2) to the power steering gear.

Tighten the fitting to 27 N.m (20 lb ft).

3. Install the power steering pressure hose (2) to the power steering pump (1).

Tighten the fitting to 27 N.m (20 lb ft).

4. Install the power steering pump pulley.
5. Bleed the power steering system.