Parking Brake Warning Switch: Service and Repair

Park Brake Warning Lamp Switch Replacement

Removal Procedure




1. Remove the console.
2. Remove the passenger seat.
3. Lift and disengage the retainer clips on the park brake lever boot.




4. Lift the park brake lever slightly until it engages the first stop.
5. Remove the park brake lever assembly mounting bolts.
6. Disconnect the electrical connector from the park brake switch.
7. Position the park brake lever assembly to the rear of the vehicle.
8. Remove the park brake switch.

Installation Procedure




1. Install the park brake switch to the park brake lever assembly.
2. Position the park brake lever assembly to the driveline tunnel.
3. Connect the electrical connector to the park brake switch.

Notice: Refer to Fastener Notice.

4. Install the mounting bolts to the park brake lever assembly.

Tighten the park brake lever assembly mounting bolts to 28 N.m (21 lb ft).




5. Position the park brake lever assembly boot to the driveline tunnel.
6. Install the park brake lever assembly boot nuts.

Tighten the park brake lever assembly boot nuts to 10 N.m (89 lb in).

7. Install the passenger seat.
8. Install the console.
9. Release the park brake lever.