Programming and Relearning

Control Module Setup (SCLCM Setup)

Important:

* When replacing a steering column lock control module (SCLCM) with a GM SPO Replacement Part, insure the procedure to setup a new SCLCM is performed.

* When replacing an SCLCM with a GM SPO Replacement Part, the new SCLCM will learn the incoming fuel continue password of the remote control door lock receiver (RCDLR) immediately upon the next ignition switch from OFF to CRANK. A SCLCM which had been installed in another vehicle will have learned the fuel continue password of the other vehicles RCDLR. Perform the SCLCM procedure to learn the fuel continue password of the current vehicles RCDLR.

Set Up Steering Column Lock Control Module

1. Turn ON the ignition, with the engine OFF.
2. Connect a scan tool to the vehicle.
3. With a scan tool, select Vehicle Control Systems.
4. Select Computer/Integrating Systems.
5. Select Module Replacement/Setup.
6. Select SCLCM Setup (Export Only).
7. Select SCLCM Setup.
8. Follow the scan tool on-screen instructions.