Rear Suspension

Tie Rod Replacement (Inner)

Removal Procedure




1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Disconnect the outer tie rod end from the suspension knuckle.
4. Remove the nut (1) retaining the rear suspension adjustment link to the crossmember.
5. Remove the rear suspension adjustment link (2) from the vehicle.

Installation Procedure




1. Install the rear suspension adjustment link (2) to the vehicle.

Notice: Refer to Fastener Notice.

2. Install the rear suspension adjustment link nut (1) to the back side of the crossmember.

Tighten the rear suspension adjustment link nut to 60 N.m (44 lb ft).

3. Install the outer tie rod end into the suspension knuckle.
4. Install the tire and wheel assembly.
5. Lower the vehicle.
6. Adjust the rear wheel toe as necessary. Refer to Rear Toe Adjustment.