Gear Select/Skip Shift Solenoid Replacement

Gear Select/Skip Shift Solenoid Replacement

Tools Required

J 41099 Gear Select/Reverse Lockout Solenoid Socket

Removal Procedure




1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the gear select solenoid electrical connector.




3. Using the J 41099, remove the gear select solenoid.

Installation Procedure





Notice: Refer to Fastener Notice in Service Precautions.

1. Using the J 41099, install the gear select (skip shift) solenoid.

Tighten the gear select solenoid to 40 N.m (30 lb ft).




2. Connect the gear select solenoid electrical connector.
3. Lower the vehicle.