Dome Lamp Replacement (Impala w/SEO, RPO 6C7)

Dome Lamp Replacement (Impala w/SEO, RPO 6C7)

Removal Procedure




1. Remove the (TRK/ROOF BRP) fuse before starting dome lamp removal procedures.
2. Remove the dome lamp lens from the dome lamp bezel using a small flat bladed tool.




3. Remove the dome lamp bulb.

Important: Hold the dome lamp bezel in position when removing the screws from the dome lamp bezel. Remove the dome lamp bezel slowly to avoid loosing the dome lamp spacers.

4. Remove the screws from the dome lamp bezel.




5. Remove the dome lamp bezel from the headliner (5).
6. Disconnect the electrical connector if required.

Installation Procedure




1. Connect the electrical connector if required.
2. Position the done lamp spacers and wiring harness ground terminal to the dome lamp bezel and screws (3).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the dome lamp bezel as an assembly to the dome lamp bracket with the dome lamp switch to the rear.

Tighten the dome lamp screws to 1.5 N.m (17 lb ft).

4. Install the dome lamp bulb.




5. Install the dome lamp lens.
6. Install the (TRK/ROOF BRP) fuse.