Oil Pressure Sensor: Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the oil pressure sensor heat shield nut and shield.
3. Disconnect the engine oil pressure sensor electrical connector (1).
4. Remove the engine oil pressure sensor.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the engine oil pressure sensor.
Tighten the sensor to 16 N.m (12 lb ft).
2. Connect the engine oil pressure sensor electrical connector (1).
3. Install the oil pressure sensor heat shield and nut.
Tighten the nut to 10 N.m (89 lb in).
4. Lower the vehicle.