C0569

DTC C0569

DTC Descriptor
DTC C0569 00
- System Configuration Error

Diagnostic Fault Information

Perform the Diagnostic System Check - Tire Pressure Monitoring prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview

Circuit/System Description

The remote control door lock receiver (RCDLR) receives a radio frequency (RF) transmission from each tire pressure sensor. Each sensors RF transmission contains its own unique identification (ID) code that must be learned into the RCDLR memory. Once all 4 IDs have been learned and vehicle speed is 25 mph, or greater, the RCDLR continuously compares IDs in received transmission to its learned IDs to determine if all 4 sensors are present.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The RCDLR has not undergone the tire type and tire pressure selection setup procedure.

Action Taken When the DTC Sets

The driver information center (DIC) displays the SERVICE TIRE MONITOR warning message.
Conditions for Clearing the DTC

A current DTC will clear when the RCDLR has undergone the setup procedure.

Diagnostic Aids

A newly replaced RCDLR will set DTC C0569 on its initial ignition ON cycle. Tire type and tire pressure selection setup must be performed. Refer to Repair Instructions.

Reference Information
Schematic Reference

Tire Pressure Monitoring System Schematics
Description and Operation

Tire Pressure Monitor Description and Operation
Scan Tool Reference

Scan Tool Data List
Special Tools Required

J-46079 Tire Pressure Monitor Diagnostic Tool

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

Programming and Relearning Programming and Relearning