Oil Pump Drive Replacement

Oil Pump Drive Replacement

Removal Procedure




1. Remove the intake manifold cover.
2. Remove the oil pump drive bolt.
3. Remove the oil pump drive.
4. Remove the oil pump drive seal.

Installation Procedure




1. Install the oil pump drive seal. Coat the seal or bore in the engine block with clean engine oil.
2. Apply prelube to the oil pump drive gear. Refer to Sealers, Adhesives, and Lubricants for the 3.9L engine.
3. Install the oil pump drive.

Notice: Refer to Fastener Notice.

4. Install the oil pump drive bolt.

Tighten the bolt to 50 N.m (37 lb ft).

5. Install the intake manifold cover.