Remote Control Door Lock Receiver Programming and Setup

Remote Control Door Lock Receiver Programming and Setup

Remote Control Door Lock Receiver Replacement

If the remote control door lock receiver is replaced, the following procedures must be performed:

1. RCDLR Programming - Refer to Service Programming System (SPS). Programming and Relearning
2. Keyless Entry Transmitter Programming - Refer to Transmitter Programming. Programming and Relearning
3. Tire Type Setup:

1. Install a scan tool.
2. Select Remote Control Door Lock Receiver under Module Setup in the Vehicle Control System menu.
3. Select Tire Type/Pressure Selection.
4. Follow the on-sceen instructions.

4. Tire Pressure Monitoring Sensor Learn - Refer to Tire Pressure Sensor Learn.

Replacing Keyless Entry Transmitters

If a keyless entry transmitter is replaced, the following procedure must be performed:

Keyless Entry Transmitter Programming-Refer to Transmitter Programming. Programming and Relearning