B3130

DTC B3130

DTC Descriptor
DTC B3130 00
- Passenger Door Unlock Circuit

Diagnostic Fault Information

Important: Always perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview





Circuit/System Description

When the passenger door lock switch is place in to the UNLOCK position, ground is applied through the switch to the body control module (BCM). The BCM then applies ground through the passenger door unlock relay control circuit to the coil side of the passenger unlock relay in the body electrical center (BEC). The relay then engages and applies voltage to all of the passenger door lock assemblies.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The BCM receives a voltage signal on the passenger door unlock relay control circuit.

Action Taken When the DTC Sets

The BCM cease attempt to unlock the doors.

Conditions for Clearing the DTC

The BCM clears this code from current when the fault is removed from the system.

Circuit/System Verification

Ignition ON, place the driver door lock switch to the UNLOCK position. The driver door should unlock.

Circuit/System Testing

1. Disconnect the BEC connector C1. Verify the DTC resets.

• If the DTC does not reset, replace the BEC.

2. Test for a short to voltage in the passenger door unlock relay control circuit.

• If all circuits/connections test normal, replace the BCM.

Repair Instructions

Important: Always perform the Diagnostic Repair Verification after completing the diagnostic procedure.

* Programming and Relearning Programming and Relearning
* Instrument Panel Electrical Center or Junction Block Replacement - Right Side (Impala) Instrument Panel Electrical Center or Junction Block Replacement - Right Side (Monte Carlo) Verification Tests