Ignition Lock Cylinder Case Replacement

Ignition Lock Cylinder Case Replacement

Removal Procedure






Caution: Refer to SIR Caution.

1. Disable the SIR system. Refer to SIR Disabling and Enabling.
2. Remove the ignition lock cylinder.
3. Remove the ignition switch.
4. Remove the steering column tilt head components.
5. Remove the turn signal switch housing.
6. Remove the turn signal and multifunction switch assembly only.




7. Remove the park lock cable assembly (1) from the ignition lock cylinder case in the following way:

1. Use a small blade to push against the locking tab on the end of the park lock cable assembly (1).
2. Disconnect the park lock cable assembly (1) from the ignition lock cylinder case.




8. Remove the 3 TORX(R) screws (2) from the ignition lock cylinder case (1).
9. Remove the ignition lock cylinder case (1) from the steering column tilt head assembly.

Installation Procedure




1. Align the ignition lock cylinder case (1) with the steering column tilt head assembly.

Notice: Refer to Fastener Notice.

2. Screw the 3 TORX(R) screws (2) into the ignition lock cylinder case (1).

Tighten the 3 TORX(R) screws to 7 N.m (62 lb in).




3. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the ignition lock cylinder case.





Important: Press the turn signal switch housing firmly against the steering column tilt head in order for the screws from the turn signal and multifunction switch assembly to align.

4. Install the turn signal switch housing.
5. Install the turn signal and multifunction switch assembly only.
6. Install the steering column tilt head components.
7. Install the ignition switch only.
8. Install the ignition lock cylinder.
9. Enable the SIR system. Refer to SIR Disabling and Enabling.