Instrument Cluster Replacement

Instrument Cluster Replacement

Removal Procedure




1. Remove the instrument panel (I/P) cluster trim plate bezel.
2. Remove the I/P cluster screws.
3. Remove the I/P cluster.
4. Remove the I/P cluster wire harness connector.

Installation Procedure




1. Install the I/P cluster wire harness connector.
2. Install the I/P cluster.

Notice: Refer to Fastener Notice.

3. Tighten the I/P cluster screws.

Tighten the screws to 2.5 N.m (22 lb in).

4. Install the I/P cluster trim plate bezel.
5. Refer to Control Module References for programming and setup information.