Oil Pressure Sensor: Service and Repair

Engine Oil Pressure Sensor and/or Switch Replacement

Removal Procedure




1. Disconnect the negative battery cable.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
3. Disconnect the engine wiring harness electrical connector (1) from the oil pressure sensor.




4. Remove the oil pressure sensor.

Installation Procedure





Notice: Refer to Fastener Notice.

1. Install the oil pressure sensor.

Tighten the sensor to 22 N.m (16 lb ft).




2. Connect the engine wiring harness electrical connector (1) to the oil pressure sensor.
3. Lower the vehicle.
4. Connect the negative battery cable.