HVAC - Manual
HVAC Control Module Replacement
Removal Procedure
1. Remove the instrument panel (I/P) center trim panel.
2. Remove the HVAC control module screws.
3. Remove the HVAC control module.
4. Remove the HVAC control module wire harness connectors.
Installation Procedure
Important: The key should be in the OFF position when connecting the electrical connectors to ensure proper calibration.
1. Install the HVAC control module wire harness connectors.
2. Install the HVAC control module.
Notice: Refer to Fastener Notice.
3. Tighten the HVAC control module screws.
Tighten the screws to 2.5 N.m (22 lb in).
4. Install the I/P center trim panel.
Important: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating. If interrupted improper HVAC performance will result.
5. Start the engine and let run for one minute.
6. Refer to Control Module References for programming and setup information.