P0572

DTC P0572

Circuit Description

The body control module (BCM) receives a signal from the brake pedal position sensor through the brake position sensor signal circuit. The BCM then applies a signal through the stop lamp switch signal circuit to the power control module (PCM).

DTC Descriptor

This diagnostic procedure supports the following DTC:

DTC P0572 Cruise Control Brake Switch Circuit Low Voltage

Conditions for Running the DTC

* The vehicle has cycled from 0-60 km/h (0-37 mph) 3 times in 1 ignition cycle.
* Continuous once the previous criteria have been met.

Conditions for Setting the DTC

The PCM detects voltage on the stop lamp switch signal circuit when the circuit should be open.

Action Taken When the DTC Sets

* The PCM stores the DTC information into memory when the diagnostic runs and fails.
* The malfunction indicator lamp (MIL) will not illuminate.
* The PCM records the operating conditions at the time the diagnostic fails. The PCM stores this information in the Failure Records.

Conditions for Clearing the DTC

* A last test failed, or current DTC, clears when the diagnostic runs and does not fail.
* A history DTC will clear after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
* Use a scan tool in order to clear the DTC.

Diagnostic Aids

Important:
* Verify that the brake pedal position sensor is adjusted properly. Refer to Brake Pedal Position Sensor Calibration. Programming and Relearning

* Test drive the vehicle if a switch or circuit condition cannot be located. An intermittent condition may be duplicated during a test drive.

* For an intermittent, refer to Testing for Intermittent Conditions and Poor Connections. Component Tests and General Diagnostics

Test Description

Step 1 - Step 7:

The number below refers to the step number on the diagnostic table.
2. This step determines if the fault is present.