Front Door Window Motor: Service and Repair

Front Side Door Window Regulator Motor Replacement

Removal Procedure

1. Open the front door.
2. Remove the front door trim panel.
3. Remove the water deflector.
4. Disconnect the electrical connector from the front door window regulator motor.




5. Remove the window from the regulator. Raise the window. Tape the window into position
6. Remove the front door window regulator.




7. Remove the 3 screws (1) from the regulator motor.

Installation Procedure




1. Align the front door window regulator motor assembly to the front door window regulator.

Notice: Refer to Fastener Notice.

2. Install the front door window regulator motor to regulator screws (1).




3. Position the front door window regulator through the opening in the door.
4. Install the front door window regulator to door screws.

Tighten the front door window regulator motor to door screws to 10 N.m (89 lb in).

5. Connect the electrical connector to the front door window regulator motor.
6. Install the water deflector.
7. Install the front door trim panel.
8. Close the front door.