Rear Door Window Regulator: Service and Repair

Rear Side Door Window Regulator Replacement

Removal Procedure




1. Remove the rear door trim panel.
2. Remove the rear door water deflector.
3. Raise the rear door window far enough in order to gain access through the inner door to the window to the window peg retainer.
4. Remove the nylon peg from the rear door window to regulator.
5. Raise the rear door window to the full up position.
6. Tape the rear door window in the full up position.
7. Disconnect the electrical connector.
8. Remove the bolts on the regulator motor (1). Lift the motor to free the retaining bolts from the slots (2).




9. Remove the bolts from the rear door window regulator (1).
10. Remove the rear door window regulator from the rear door.

Installation Procedure




1. Install the rear door window regulator and the motor to the door.






Notice: Refer to Fastener Notice.

2. Install the regulator mounting bolts (1).

Tighten the rear door window regulator bolts to 10 N.m (89 lb in).

3. Connect the electrical connector.
4. Remove the tape from the rear door window.
5. Lower the rear door window far enough to install the door window.
6. Install the bolts to the rear door window regulator (1, 2).

Tighten the window regulator bolts to 10 N.m (89 lb in).

7. Install the rear door water deflector.
8. Install the rear door trim panel.