Air Temperature Sensor ( Ambient / Intake ): Service and Repair

Mass Airflow Sensor/Intake Air Temperature Sensor Replacement

Removal Procedure




1. Remove the air cleaner outlet duct.
2. Disconnect the engine wiring harness electrical connector from the mass air flow (MAF)/intake air temperature (IAT) sensor.




3. Remove the MAF/IAT sensor screws (1).
4. Remove the MAF/IAT sensor (2).
5. Remove and discard the MAF/IAT sensor O-ring seal.

Installation Procedure




1. Install the NEW MAF/IAT sensor O-ring seal.
2. Install the MAF/IAT sensor (2).

Notice: Refer to Fastener Notice.

3. Install the MAF/IAT sensor screws (1).

Tighten the screws to 1.5 N.m (44 lb in).




4. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
5. Install the air cleaner outlet duct.