Cylinder Head Assembly

Cylinder Head Surface Variation
^ Check the sealing surfaces for damage. The cylinder head sealing surfaces must be flat within 0.050 mm (0.002 in) maximum.

^ The cylinder head height should be 134.08-134.23 mm (5.279-5.285 in). If the cylinder head height is less than this value, replace the cylinder head.





Camshaft Cap Bolts 16 N.m (12 lb ft)





Cylinder Head Bolts - Camshaft Support Housing and Cylinder Head Mounting Bolts 25 N.m+60°+60°+60°+15° (18 lb ft+60°+60°+60°+10°)






Exhaust Manifold Heat Shield Bolts 15 N.m (11 lb ft)
Exhaust Manifold Nuts 25 N.m (18 lb ft)





Intake Manifold Retaining Nuts 25 N.m (18 lb ft)
Intake Manifold Support Bracket Lower Bolt-to-Engine Block 40 N.m (30 lb ft)
Intake Manifold Support Bracket Upper Bolts 25 N.m (18 lb ft)

Camshaft Gear Bolt 67.5 N.m (49 lb ft)