Differential Assembly Disassemble

Differential Assembly Disassemble

Tools Required
* DT 46463 (DW240-150) Transaxle Case Side Bearing Outer Race Adapter
* DT 46465 (DW240-170) Adapter Handle






1. Place the matchmarks (1) on the ring gear and differential case.




2. Remove the 8 bolts.




3. Using a plastic hammer, tap on the ring gear to remove it from the case.




4. Using a suitable puller, remove the tapered roller bearing of transaxle housing side.




5. Using a suitable puller, remove the tapered roller bearing of transaxle case side.




6. Using a pin punch and hammer, drive out the pin from the ring gear side.




7. Remove the differential pinion shaft from the case.




8. Remove the 2 differential pinion gears, 2 differential side gears, 2 differential pinion thrust washers, and 2 differential side gear thrust washers.




9. Using a driver, remove the oil seal from the transaxle housing.




10. Using a suitable puller, remove the side bearing outer race of transaxle housing.




11. Using a driver, remove the oil seal of transaxle case.




12. Using the DT 46463 (2) and the DT 46465 (1), remove the transaxle case side bearing outer race and shim.