Oil Feed Pipes Replacement

Oil Feed Pipes Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution .

1. Disconnect the negative battery cable.
2. Raise the vehicle. Support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the transmission oil pan. Refer to Oil Pan Replacement (Service and Repair) .
4. Remove the transmission oil filter assembly. Refer to Automatic Transmission Fluid Filter and Seal Replacement (Service and Repair) .




5. Remove the oil feed pipe bolts.
6. Inspect the eight oil feed pipe seal rings.
7. Replace the seal rings only if the seal rings are cut, swollen or damaged.




8. Remove the low/reverse band oil pipe assembly.
9. Remove the eight low/reverse band oil pipe assembly seals.
10. Inspect the oil feed pipes for plugged passages, bent pipes, or cracks.
11. Inspect the oil feed pipe seal rings. Verify the proper location of the seal rings. Replace the seal rings if these are cut, swelled or damaged.



Installation Procedure





1. Install the eight low/reverse band oil pipe assembly seals.
2. Install the low/reverse band oil feed pipe assembly onto the transmission.





Notice: Refer to Fastener Notice .

3. Hand start the bolts that attach the oil feed pipe assembly to the transmission.

Tighten the bolts to 14 N.m (124 lb in).

4. Install the transmission oil filter assembly. Refer to Automatic Transmission Fluid Filter and Seal Replacement (Service and Repair) .
5. Install the transmission oil pan and gasket. Refer to Automatic Transmission Fluid Filter and Seal Replacement (Service and Repair) .
6. Lower the vehicle.
7. Refill the transmission to the proper level.
8. Inspect the transmission oil level. Refer to Transmission Fluid Check (Transmission Fluid Checking Procedure) .

Important: It is recommended that transmission adaptive pressure (TAP) information be reset.


Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.


9. Reset the TAP values. Refer to Transmission Adaptive Functions (Transmission Adaptive Functions) .