Automatic Day-Night Mirrors Inoperative
Automatic Day-Night Mirrors Inoperative
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview)provides an overview of each diagnostic category.
Circuit/System Description
The automatic day/night feature of the driver outside rearview mirror is controlled by the inside rearview mirror. The inside rearview mirror supplies a signal and a low reference to the driver outside rearview mirror. The voltage on the signal circuit of the driver outside rearview mirror varies between 0.5-1.5 volts depending on light conditions present at the inside rearview mirror. At night, with the automatic day-night feature enabled, the driver outside rearview mirror will automatically darken with the inside rearview mirror to reduce the glare from the headlamps from behind. The voltage on the signal circuit of the driver outside rearview mirror will be near 1.5 volts. In daytime conditions, the mirrors are in the normal state. The voltage on the signal circuit of the driver outside rearview mirror may be less than or near 0.5 volts. For more detailed information concerning automatic day night mirror operation refer to Automatic Day-Night Mirror Description and Operation (Automatic Day-Night Mirror Description and Operation) .
Diagnostic Aids
This diagnostic assumes that the vehicles backup lamps are operating within specifications. If the backup lamps are inoperative, diagnose the backup lamps system before continuing with this procedure.
Reference Information
Schematic Reference
* Inside Rearview Mirror Schematics (Inside Rearview Mirror Schematics)
* Outside Rearview Mirror Schematics (Outside Rearview Mirror Schematics)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Outside Mirror Description and Operation (Outside Mirror Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning)for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the inside rearview mirror.
2. Ignition OFF, test for less than 1.0 ohm of resistance between the ground circuit terminal 8 and ground.
• If greater than the specified range, test the ground circuit for an open/high resistance.
3. Ignition ON, test for battery voltage between the ignition 1 voltage circuit terminal 13 and ground.
• If less than the specified range, test the voltage circuit terminal 13 for a short to ground or an open/high resistance.
4. Transmission in REVERSE, test for battery voltage between the backup lamps supply voltage circuit terminal 9 and ground.
• If less than the specified range, test the voltage circuit terminal 9 for a short to ground or an open/high resistance.
5. If all circuits test normal, test or replace the inside rearview mirror.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
Inside Rearview Mirror Replacement (Except DD8) (Inside Rearview Mirror Replacement (Except DD8))Inside Rearview Mirror Replacement (DD8) (Inside Rearview Mirror Replacement (DD8))