B3634
DTC B3634
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
DTC Descriptor
DTC B3634
- Head-Up Display (HUD) Dimming Up Switch Short to Ground
Diagnostic Fault Information
Circuit/System Description
The head-up display (HUD) dim up switch is a momentary contact switch that adjusts the HUD display brightness. The HUD dim up switch controls the intensity of the brightness. The HUD senses when the dim up switch is active and adjusts the display brightness until the desired intensity is attained. When the HUD dim up switch is pressed and the ignition is in the RUN position, the dim up switch signal to the HUD is low. A press and hold of the dim up switch greater than 1 second initiates a smooth increase in the HUD intensity until the switch is released or maximum intensity is achieved.
Conditions for Running the DTC
The ignition is in RUN.
Conditions for Setting the DTC
The HUD detects that the HUD dim up switch signal circuit is low for greater than 60 seconds.
Action Taken When the DTC Sets
The HUD ignores the malfunctioning switch circuit.
Conditions for Clearing the DTC
* The DTC becomes history when the conditions for setting the DTC are no longer present.
* The history DTC clears after 40 malfunction-free warm-up cycles.
Reference Information
Schematic Reference
Head Up Display Schematics (Head Up Display Schematics)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Head Up Display (HUD) Description and Operation (Head Up Display (HUD) Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning)
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the HUD.
2. Verify a test lamp does not illuminate when connected between the HUD dimming up switch signal circuit terminal 11 and B+.
• If the test light illuminates, test the circuit for a short to ground. If the circuit tests normal, replace the HUD.
3. If all circuits test normal, test or replace the HUD switch.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
* Control Module References (Programming and Relearning)
* Head Up Display Switch Replacement (Head Up Display Switch Replacement)