Lift Off Panel Weatherstrip Retainer Replacement

Lift Off Panel Weatherstrip Retainer Replacement

Removal Procedure





1. Remove the roof panel , place the roof panel upside down on a flat protective surface.
2. Remove the side weatherstrip. Refer to Lift Off Panel Weatherstrip Replacement (Lift Off Panel Weatherstrip Replacement) .




3. Remove the screws attaching the retainer to the roof panel .
4. Remove the retainer.



Installation Procedure





1. Position the retainer to the roof panel, ensure that the molded end of the rubber is located towards the front of the roof panel .

Notice: Refer to Fastener Notice .

2. Install the forward screw aligning the retainer fore and aft.

Important: Stripped, broken, or improperly seated screws must be replaced or repaired to prevent water leaks.


3. Install the remaining screws.

Tighten the side weatherstrip retainer screws to 3 N.m (27 lb in).

4. Install the roof panel.