14. Valve Rocker Arm Cover Removal - Right Side

Valve Rocker Arm Cover Removal - Right Side (7.0L)






Important: Do not remove the oil cap from the cover, unless service is required. If the oil cap has been removed from the cover, the locking features of the cap will be damaged and no longer functional.


If the cap has been removed, install a NEW cap during assembly.


1. Remove the spark plug wires (724).
2. Remove the ignition coil bracket studs (720).
3. Remove the ignition coil and bracket assembly (719).




4. Disconnect the ignition coil electrical connectors.
5. Remove the bolts (723), coils (722), and wire harness (721) from the bracket, as required.




6. Remove the valve rocker arm cover bolts (516) and cover (505).




7. Remove the gasket (504) from the cover.





Important: If the oil cap is removed from the cover, install a NEW cap during assembly.


8. Remove the oil cap (424) and seal (450) from the cover, only if replacement is required.
9. Discard the oil cap.