Battery Positive Fuse Block Cable Replacement

Battery Positive Fuse Block Cable Replacement

Removal Procedure





1. Remove the battery tray. Refer to Battery Tray Replacement (Service and Repair) .
2. Open the stud cover on the fuse/relay center cover.
3. Remove the positive battery cable nut (1).
4. Remove the positive battery cable lead from the stud.
5. Remove the battery positive fuse block cable from the stud.




6. Disengage the kick-up panel latches inside the vehicle.
7. Open the panel.
8. Lift the panels bottom edge up and out of the slots in the multi-use relay bracket.
9. Remove the kick-up panel.




10. Unsnap the junction block from the bracket.
11. Reposition the junction block nut boot.
12. Remove the instrument panel (I/P) wiring harness junction block nut.
13. Remove the battery positive fuse block cable from the stud.
14. Route the fuse block cable through the front of dash and remove the cable.



Installation Procedure





1. Install and route the fuse block cable through the front of dash.
2. Install the battery positive fuse block cable to the stud.

Notice: Refer to Fastener Notice (Fastener Notice) .

3. Install the I/P wiring harness junction block nut.

Tighten the I/P wiring harness junction block nut to 10 N.m (89 lb in).

4. Reposition the junction block nut boot.
5. Snap the junction block to the bracket.




6. Ensure the latches on the kick-up panel are open.
7. Insert the kick-up panel lower tabs into the slots in the bracket.
8. Close the panel and push the latches into the holes.




9. Install the battery positive fuse block cable to the stud.
10. Install the positive battery cable lead to the stud.
11. Install the positive battery cable nut (1).

Tighten the positive battery cable nut to 10 N.m (89 lb in).

12. Close the stud cover on the fuse/relay center cover.
13. Install the battery tray. Refer to Battery Tray Replacement (Service and Repair) .