Gear Select/Skip Shift Solenoid Replacement

Gear Select/Skip Shift Solenoid Replacement

Tools Required

J 41099 Gear Select/Reverse Lockout Solenoid Socket


Removal Procedure





1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service Intervals) .
2. Disconnect the gear select solenoid electrical connector.




3. Using the J 41099 , remove the gear select solenoid.



Installation Procedure






Notice: Refer to Fastener Notice .

1. Using the J 41099 , install the gear select (skip shift) solenoid.

Tighten the gear select solenoid to 40 N.m (30 lb ft).





2. Connect the gear select solenoid electrical connector.
3. Lower the vehicle.