Reverse Lockout Solenoid Replacement

Reverse Lockout Solenoid Replacement

Tools Required

J 41099 Gear Select/Reverse Lockout Solenoid Socket


Removal Procedure





Caution: Refer to Battery Disconnect Caution (Battery Disconnect Caution) .
1. Disconnect the negative battery cable.
2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle (Service Intervals) .
3. Remove the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
4. Remove the intermediate exhaust pipe to muffler bolts.
5. Tie off the mufflers to the underbody to support out of the way.
6. Remove the rear transverse spring. Refer to Rear Transverse Spring Replacement (Rear Suspension Leaf Spring) .
7. Disconnect the wiring harness and brake pipe clip retainers from the rear suspension crossmember.
8. Position a transmission jack under the rear suspension crossmember and firmly secure the crossmember to the jack.
9. Using ONLY HAND TOOLS, remove the rear suspension crossmember mounting nuts.

Important: Observe the clearance between the driveline and the driveline tunnel closeout panel.


10. Slowly lower the rear suspension crossmember, along with the attached driveline, approximately 4 cm (11/2 in).
Lower the rear suspension crossmember and driveline for access to the reverse lockout solenoid.




11. Disconnect the reverse lockout solenoid electrical connector.




12. Using the J 41099 , remove the reverse lockout solenoid.



Installation Procedure






Notice: Refer to Fastener Notice (Fastener Notice) .

1. Using the J 41099 , install the reverse lockout solenoid.

Tighten the reverse lockout solenoid to 40 N.m (30 lb ft).





2. Connect the reverse lockout solenoid electrical connector.




3. Slowly raise the rear suspension crossmember to seat to the vehicle frame rails.
4. Using ONLY HAND TOOLS, install NEW rear suspension crossmember mounting nuts.

Tighten the rear suspension crossmember mounting nuts to 110 N.m (81 lb ft).

5. Remove the transmission jack from the rear suspension crossmember.
6. Connect the wiring harness and brake pipe clip retainers to the rear suspension crossmember.
7. Install the rear transverse spring. Refer to Rear Transverse Spring Replacement (Rear Suspension Leaf Spring) .
8. Remove the tie-off retainers from the muffler assemblies.
9. Install the intermediate exhaust pipe to muffler bolts.

Tighten the intermediate exhaust pipe to muffler bolts to 50 N.m (37 lb ft).

10. Install the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
11. Lower the vehicle.
12. Connect the negative battery cable.

Tighten the negative battery cable bolt to 15 N.m (11 lb ft).

13. Program the transmitters. Refer to Transmitter Programming (N. America and Japan, except Canada) (Programming and Relearning)Transmitter Programming (Canada and Europe) (Programming and Relearning) .