B2585

DTC B2585

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC B2585 00
- Left Park Lamp Control Circuit

Diagnostic Fault Information






Circuit/System Description

Battery positive voltage is applied at all times to both the coil and switched sides of the PARK LP PCB Relay. The park lamps are controlled by the body control module (BCM) by inputs from park lamp switch. When the BCM receives a park lamps ON command, it grounds the park lamps relay control circuit in order to energize the PARK LP PCB Relay. With the relay energized, battery voltage is applied through switch side of the relay, both PARK Fuses, the and the park lamp supply voltage circuits to all park, tail, and marker lamps.

Conditions for Running the DTC

The park lamps must be commanded on by the BCM.

Conditions for Setting the DTC

The BCM detect a short to voltage on the park lamp relay control circuit.

Action Taken When the DTC Sets

The BCM will deactivate the park lamp relay for the remainder of the ignition cycle.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.

Circuit/System Verification

Ignition ON, turn the park lamps on. The park lamps should illuminate.

Circuit/System Testing

1. Ignition OFF, disconnect the X2 harness connector at the underhood fuse block.
2. Connect a test lamp between the control circuit terminal K2 and B+.
3. Ignition ON, command the Parking Lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.

^ If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the BCM.

^ If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.

4. If the circuit tests normal, replace the underhood fuse block.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests

* Accessory Wiring Junction Block Replacement.