Engine Electrical

DTC P0563

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P0563
- System Voltage High

Diagnostic Fault Information






Circuit/System Description

The engine control module (ECM) monitors the system voltage to ensure that the voltage stays within the proper range. Damage to components, and incorrect data may occur when the voltage is out of range.

Conditions for Running the DTC

* The vehicle speed is above 8 km/h (5 mph).
* The system voltage is between 9.5-18.0 volts.


Conditions for Setting the DTC

The ECM detects a system voltage above 16 volts for less than 1 second.

Action Taken When the DTC Sets

DTC P0563 is a C type DTC.

Conditions for Clearing the DTC

DTC P0563 is a C type DTC.

Diagnostic Aids

* A possible cause of this DTC could be overcharging with a battery charger or jump starting.
* A high voltage value in multiple modules indicates a concern in the charging system.

Circuit/System Verification

1. Verify that DTC P0563 is set as current.
2. Engine running measure and record the voltage at the battery terminals.
3. Verify that the battery voltage is 12.6-15.5 volts.

• If the battery voltage is not within the specified range, refer to Charging System Test. Charging System Test

4. Engine running, observe the scan tool ECM Ignition 1 signal parameter.
5. Verify the battery and Ignition 1 signal readings do not differ more than 2.0 volts.

• If greater than specified value, replace the ECM.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure. Verification Tests