Brake Pedal Assy: Service and Repair

Brake Pedal Assembly Replacement

Removal Procedure

1. Remove the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .
2. Push the body control module (BCM) up and move the bottom of the BCM away from and out of the mounting bracket slot. Position the BCM aside.
3. Disconnect the brake pedal position sensor electrical connector.
4. Release the wiring harness clips from the bracket.




5. Remove the brake pedal pushrod retaining clip from the brake pedal.
6. Remove the brake pedal pushrod and washer from the brake pedal.




7. Remove the brake pedal nut and bolt.
8. Remove the brake pedal and bushings.



Installation Procedure





1. Install the brake pedal and bushings.

Notice: Refer to Fastener Notice .

2. Install the brake pedal nut and bolt.

Tighten the brake pedal nut and bolt to 40 N.m (30 lb ft).





3. Install the brake pedal washer and pushrod to the brake pedal.
4. Install the brake pedal pushrod retaining clip to the brake pedal.
5. Secure the wiring harness clips to the bracket.
6. Connect the brake pedal position sensor electrical connector.
7. Insert the top of the BCM up into the mounting bracket, then engage the bottom of the BCM into the mounting bracket slot.
8. Install the left closeout/insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side .