B0005

DTC B0005

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.



DTC Descriptors
DTC B0005 00
- In Park Signal Circuit




Diagnostic Fault Information






Circuit/System Description

The body control module (BCM) monitors the status of the park brake. When the BCM receives a ground input from the park brake switch, a serial data message is sent to the instrument panel cluster (IPC) requesting illumination of the red brake warning indicator.


Conditions for Running the DTC

The ignition is ON.


Conditions for Setting the DTC

The vehicle speed is greater than 8 km/h (5 mph) and the BCM receives a ground from the park brake switch.


Action Taken When the DTC Sets

The Red Brake Warning indicator illuminates.


Conditions for Clearing the DTC

* The condition for the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.



Diagnostic Aids

This DTC may indicate that the vehicle has been driven with the park brake engaged.


Reference Information
Schematic Reference

Hydraulic Brake Schematics ([1][2]Electrical Diagrams)
Connector End View Reference

Component Connector End Views
Description and Operation

Brake Warning System Description and Operation (Brake Warning System Description and Operation)
Electrical Information Reference

* Circuit Testing
* Connector Repairs
* Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information


Circuit/System Verification

Ignition ON, observe the scan tool BCM Park Brake Switch parameter. The reading should be Inactive and change between Active and Inactive when pressing and depressing the park brake.


Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the park brake switch.
2. Ignition ON, verify the scan tool BCM Park Brake Switch parameter is Inactive.

• If not the specified value, test the signal circuit terminal A for a short to ground. If the circuit tests normal, replace the BCM.

3. Install a 3A fused jumper wire between the signal circuit terminal A and ground. Verify the scan tool BCM Park Brake Switch parameter is Active.

• If not the specified value, test the signal circuit for a short to voltage or an open/high resistance.

4. If all circuits test normal, test or replace the park brake switch.



Component Testing

1. Ignition OFF, disconnect the harness connector at the park brake switch.
2. Test for infinite resistance between the park brake switch terminal A and ground, with the park brake released.

• If less than specified range, replace the park brake switch.

3. Test for less than 1 ohm between the park brake switch terminal A and ground with the park brake applied.

• If greater than specified range, replace the park brake switch.




Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

* Parking Brake Indicator Switch Replacement (Service and Repair)
* Control Module References for BCM and replacement, setup, and programming