C0240

DTC C0240

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.



DTC Descriptor
DTC C0240
- ECM Traction Control Not Allowed




Circuit/System Description

The powertrain control module (PCM) monitors various parameters and will not allow traction control operation if any parameter falls outside a specified range.


Conditions for Running the DTC

* The ignition is ON.
* Ignition voltage is greater than 8 volts.



Conditions for Setting the DTC

The PCM sends a serial data message to the electronic brake control module (EBCM) indicating that torque reduction is temporarily not allowed.


Action Taken When the DTC Sets

* The EBCM disables the TCS until the DTC becomes a history DTC.
* The Traction Off indicator turns ON.
* The ABS remains functional.



Conditions for Clearing the DTC

* The condition for the DTC is no longer present and the DTC is cleared with a scan tool.
* The electronic brake control module (EBCM) automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.



Diagnostic Aids

This DTC indicates that there are no problems in the ABS/TCS system. The DTCS of the ECM should be checked for a possible fault.


Reference Information
Schematic Reference

Antilock Brake System Schematics ([1][2]Antilock Brakes / Traction Control Systems)
Connector End View Reference

Component Connector End Views
Description and Operation

ABS Description and Operation (Description and Operation)
Electrical Information Reference

* Circuit Testing
* Connector Repairs
* Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs

Scan Tool Reference

Control Module References for Scan Tool Information