Oil Pressure Sensor: Service and Repair

Engine Oil Pressure Sensor and/or Switch Replacement

Removal Procedure





1. Remove the starter. Refer to Starter Motor Replacement (LZ4) Starter Motor Replacement (LAT) Starter Motor Replacement (LY7) .
2. Disconnect the engine wiring harness electrical connector (2) from the oil pressure sensor.




3. Remove the engine oil pressure sensor.



Installation Procedure






Notice: Refer to Fastener Notice .

1. Install the engine oil pressure sensor.

Tighten the sensor to 22 N.m (16 lb ft).





2. Connect the engine wiring harness electrical connector (2) to the oil pressure sensor.
3. Install the starter. Refer to Starter Motor Replacement (LZ4) Starter Motor Replacement (LAT) Starter Motor Replacement (LY7) .