Evaporative Emission Control Canister: Service and Repair

Evaporative Emission Canister Replacement

Removal Procedure




1. Remove the fuel tank.
2. Disconnect the fuel tank vent pipe quick connect fitting (1) from the EVAP canister.
3. Disconnect the evaporative emission (EVAP) canister pipe quick connect fitting (2) from the EVAP canister vent solenoid valve.



4. Remove the EVAP canister purge pipe from the retaining feature (3) built into the fuel tank.
5. Reposition the fuel tank fuel pump wiring harness from around the EVAP canister.




6. Remove the EVAP canister bolt.
7. Slide up and remove the EVAP canister.

Installation Procedure




1. Position and install the EVAP canister.

Notice: Refer to Fastener Notice.

2. Install the EVAP canister bolt.

Tighten the bolt 3.5 N.m (31 lb in).




3. Position the fuel tank fuel pump wiring harness around the EVAP canister.
4. Install the EVAP canister purge pipe to the retaining feature (3) built into the fuel tank.




5. Connect the EVAP canister pipe quick connect fitting (2) to the EVAP canister vent solenoid valve.
6. Connect the EVAP canister vent pipe quick connect fitting (1) to the EVAP canister.
7. Install the fuel tank.