Rear Suspension

Rear Wheel Bearing and Hub Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement .




4. Disconnect the electrical connector from the wheel speed sensor.
5. Remove the 4 wheel bearing/hub assembly nuts.
6. Remove the wheel bearing/hub assembly from the knuckle.



Installation Procedure





1. Install the wheel bearing/hub assembly to the knuckle.

Notice: Refer to Fastener Notice .

2. Install the 4 wheel bearing/hub assembly nuts.

Tighten the nuts to 63 N.m (47 lb ft).

3. Install the stabilizer link bolt at the knuckle. Refer to Stabilizer Shaft Replacement (Rear Suspension) .
4. Connect the electrical connector to the wheel speed sensor.
5. Install the brake rotor. Refer to Rear Brake Rotor Replacement .
6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (Service and Repair) .
7. Lower the vehicle.