Without Variable Camshaft Phasing

DTC P0315

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.

DTC Descriptor
DTC P0315
- Crankshaft Position (CKP) System Variation Not Learned

Circuit/System Description

The crankshaft position (CKP) system variation learn feature is used to calculate reference period errors caused by slight tolerance variations in the crankshaft, and the crankshaft position sensor. The calculated error allows the engine control module (ECM) to accurately compensate for reference period variations. This enhances the ability of the ECM to detect misfire events over a wider range of engine speed and load.

The CKP system variation compensating values are stored in ECM memory after a learn procedure has been performed. If the actual CKP variation is not within the CKP system variation compensating values stored in the ECM, DTC P0300 may set.

If the CKP system variation values are not stored in the ECM memory, DTC P0315 sets.

Conditions for Running the DTC

* DTCs P0016, P0106, P0107, P0108, P0117, P0118, P0122, P0123, P0132, P0261, P0201, P0202, P0203, P0204, P0262, P0264, P0265, P0267, P0268, P0270, P0271, P0324, P0325, P0327, P0335, P0336, P0337, P0340, P0351, P0352, P0402, P0404, P0405, P0406, P0488, P0502, and P0700 are not set.
* The engine coolant temperature (ECT) is more than 65°C (149°F).
* DTC P0315 runs continuously once the above conditions are met.

Conditions for Setting the DTC

The ECM detects that the CKP system variation values are not stored in memory.

Action Taken When the DTC Sets

DTC P0315 is a Type B DTC.

Conditions for Clearing the DTC

DTC P0315 is a Type B DTC.

Reference Information
DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Diagnostic Trouble Code Descriptions)

Circuit/System Testing

Important: The CKP System Variation Learn Procedure may have to be repeated up to 5 times before the procedure is learned.

Perform the Crankshaft Position System Variation Learn (Service and Repair).

1. If the scan tool displays NOT learned this ignition, inspect for the following conditions:

* A worn or damaged crankshaft or crankshaft bearings
* Debris between the CKP sensor and the reluctor wheel
* A damaged reluctor wheel
* Excessive crankshaft runout
* Any interference of the CKP sensor or CKP sensor signal to the control module

2. If the control module is unable to complete the learn procedure, replace the control module.
3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

Repair Instructions

Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.

Control Module References (Programming and Relearning) for ECM replacement, setup, and programming