Power Steering Pump Belt Replacement

Power Steering Pump Belt Replacement

Removal Procedure

1. Remove the engine accessory drive belt. Refer to Drive Belt Replacement (Drive Belt Replacement).




2. Remove the RH headlamp assembly. Refer to Headlamp Replacement (Notchback) (Service and Repair)Headlamp Replacement (Hatchback) (Service and Repair).
3. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (Service and Repair).
4. Place a long bar (1) in the opening between engine and pump drive belt.

Note: This will provide a guide function for the drive belt removal.

5. Using the bar (1) push the drive belt (2) into the opposite side of engine.





Note: Outside surface of the belt should face toward the engine.

6. Rotate the pulley using 3/8 inch hex bit socket (1) in the power steering pump pulley shaft hole.
7. Rotate the power steering pump pulley clockwise while pushing the drive belt until the belt is fully removed from the pulley.

Installation Procedure




1. Route the power steering pump drive belt (1).
2. Align the drive belt on the water pump pulley first.
3. Position one of the three pulley holes on top point.




4. Through the pulley hole tie the driver belt to the pump pulley using a cable tie (1).

Note: This will provide a guide function for the drive belt (2) installation.

5. Rotate the pulley using 3/8 inch hex bit socket (3) in the power steering pump pulley shaft hole.
6. Rotate the power steering pump pulley clockwise until the belt is fully installed on the pulley.
7. Remove the rope or cable tie.
8. Inspect for correct belt installation.
9. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (Service and Repair).
10. Install the RH headlamp assembly. Refer to Headlamp Replacement (Notchback) (Service and Repair)Headlamp Replacement (Hatchback) (Service and Repair).
11. Install the engine accessory belt. Refer to Drive Belt Replacement (Drive Belt Replacement).