Without Variable Camshaft Phasing

Engine Control Module Replacement

Removal Procedure




Warning: Refer to Battery Disconnect Warning (Battery Disconnect Warning).
1. Disconnect the negative battery cable.
2. Disconnect the engine control module (ECM) connectors.




3. Remove the ECM retaining nuts.
4. Remove the ECM from the ECM mount.

Installation Procedure




1. Position the ECM in place.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the ECM to the ECM mount and install the retaining bolts.

Tighten the ECM retaining bolts to 4 Nm (35 lb in).




3. Connect the ECM connectors.
4. Connect the negative battery cable.
5. Perform the following procedures:

* Program the ECM
* Crankshaft Position System Variation Learn (Service and Repair)
* Throttle/Idle Learn (Throttle Learn)

6. Refer to Control Module References (Programming and Relearning) for programming and setup information.