Without Variable Camshaft Phasing
Crankshaft Position Sensor Replacement
Removal Procedure
Warning: Refer to Battery Disconnect Warning (Battery Disconnect Warning).
1. Disconnect the negative battery cable.
2. Disconnect the crankshaft position (CKP) sensor electrical connector.
3. Remove the CKP sensor bolt.
4. Remove the CKP sensor.
Installation Procedure
Caution: Refer to Fastener Caution (Fastener Caution).
1. Install the CKP sensor with the bolt.
Tighten the CKP sensor bolt to 6.5 Nm (58 lb in).
2. Connect the CKP sensor electrical connector.
3. Connect the negative battery cable.