Without Variable Camshaft Phasing

Fuel Tank Replacement

Removal Procedure




Warning: Refer to Relieving Fuel Pressure Warning (Service Precautions).
1. Relieve the fuel pressure. Refer to Fuel Pressure Relief (Fuel Pressure Relief).
Warning: Refer to Battery Disconnect Warning (Battery Disconnect Warning).
2. Disconnect the negative battery cable.
3. Drain the fuel tank.
4. Disconnect the parking brake cable retainer clamps and the support along the fuel tank to provide clearance for the tank.




5. Remove the fuel tank filler tube clamp at the fuel tank.
6. Disconnect the fuel tank filler tube.
7. Disconnect the fuel tank filler tube at the fuel tank.
8. Disconnect the canister vapor tube at the control valve vapor tube.




9. Disconnect the fuel line near the right front of the fuel tank.
10. Disconnect the wiring harness clips and the fuel line clips as needed.




11. Remove the front exhaust pipe. Refer to Front Pipe Replacement (Service and Repair).




12. Support the fuel tank.
13. Remove the fuel tank retaining nuts.
14. Carefully lower the fuel tank.
15. Remove the fuel tank.
16. Transfer any parts as needed.

Installation Procedure




1. Raise the fuel tank into position.

Caution: Refer to Fastener Caution (Fastener Caution).

Caution: Refer to Fuel Tank Strap Fastener Caution (Fuel Tank Strap Fastener Caution).

2. Install the fuel tank mounting straps and bolts.

Tighten the fuel tank strap retaining bolts to 20 Nm (15 lb ft).

3. Connect the fuel line.
4. Connect the wiring harness clips and the fuel line clips as needed.
5. Connect the fuel pump electrical connector.
6. Connect the fuel vapor line.
7. Connect the fuel tank filler tube and the fuel tank vent tube.
8. Install the fuel tank filler tube clamp at the fuel tank.
9. Install the front exhaust pipe. Refer to Front Pipe Replacement (Service and Repair).




10. Install the parking brake cable retainer clamps and the support.

Tighten the parking brake cable retainer clamps to 10 Nm (89 lb in).

11. Connect the negative battery cable.
12. Fill the fuel tank.
13. Perform a leak check of the fuel tank and the fuel line connections.