Without Variable Camshaft Phasing

Manifold Absolute Pressure Sensor Replacement

Removal Procedure




Warning: Refer to Battery Disconnect Warning (Battery Disconnect Warning).
1. Disconnect the negative battery cable.
2. Remove the manifold absolute pressure (MAP) sensor electrical connector.
3. Disconnect the vacuum hose.
4. Remove the MAP sensor bolt.
5. Remove the MAP sensor.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the MAP sensor with the bolt.

Tighten the MAP sensor bolt to 10 Nm (89 lb in).

2. Connect the vacuum hose.
3. Connect the MAP sensor electrical connector.
4. Connect the negative battery cable.