Tie Rod: Service and Repair

Steering Linkage Outer Tie Rod Replacement

Special Tools

KM-507-C Ball Joint Remover

Removal Procedure




1. Remove the outer tie rod hex nut and disconnect the outer tie rod from the steering knuckle using the KM-507-C .





Note: Before loosening the tie rod lock nut, mark the position of the lock nut for easy alignment after the installation procedure.

2. Loosen the tie rod lock nuts and remove the outer tie rod.

Installation Procedure





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the outer tie rod with the lock nuts.

Tighten the lock nuts to 54 Nm (40 lb ft).




2. Install the outer tie rod with the hex nut.

Tighten the hex nut to 45 Nm (33 lb ft).

3. Inspect the vehicle. Refer to Preliminary Alignment Inspection (Testing and Inspection) and Straight Ahead Inspection (Removal and Replacement).
4. Measure the wheel alignment.
5. If necessary, adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment (Service and Repair).