Transmission Case Assemble

Transmission Case Assemble





Caution: Refer to Fastener Caution (Fastener Caution).

1. Install the speedometer-driven gear into the transaxle housing.
2. Install the speedometer-driven gear bolt and tighten to 4 Nm (35 lb in).




3. Install the clutch-release bearing guide and the clutch-release bearing. Refer to Release Bearing Replacement (Service and Repair).
4. Install the backup lamp switch into the transaxle housing and tighten to 20 Nm (15 lb ft).




5. Install the differential into the transaxle housing. Refer to Differential Case Assemble (Differential Case Assemble).
6. Install the bearing plate, with the shafts attached.
7. Install the bearing plate bolts and tighten to 22 Nm (16 lb ft).




8. Install the transaxle cover.
9. Install the transaxle cover bolts and tighten to 18 Nm (13 lb ft).




10. Install the gearshift lever cover.
11. Install the gearshift lever cover bolts and tighten to 22 Nm (16 lb ft).
12. Install the transaxle into the vehicle. Refer to Transmission Replacement (D16 - Manual Transmission).