P069E
DTC P069E
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
DTC Descriptor
DTC P069E
- Fuel Pump Flow Control Module (FPCM) Requested MIL Illumination
Circuit/System Description
The fuel pump flow control module (FPCM) controls and monitors the operation of the fuel system. When the FPCM detects a fault and sets a DTC, the FPCM sends a serial data message to the engine control module (ECM) requesting the illumination of the malfunction indicator lamp (MIL). This DTC sets in the ECM when it receives a MIL request message from the FPCM.
Conditions for Running the DTC
The ignition is in crank, or the engine is running.
Conditions for Setting the DTC
The FPCM requests the ECM to illuminate the MIL.
Action Taken When the DTC Sets
DTC P069E is a Type A DTC.
Conditions for Clearing the DTC
DTC P069E is a Type A DTC.
Diagnostic Aids
Using the Failure Records data may help locate an intermittent condition. If you cannot duplicate the DTC, the information in the Failure Records can help determine how many miles since the DTC set. The Fail Counter and Pass Counter can help determine how many ignition cycles that the diagnostic test reported a pass and/or a fail.
Reference Information
Schematic Reference
Engine Controls Schematics (LS3) (Electrical Diagrams)Engine Controls Schematics (LS7) (Electrical Diagrams)Engine Controls Schematics (LS9) (Electrical Diagrams)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation
Fuel System Description (W/LS9) (Description and Operation)Fuel System Description (W/LS3 or LS7) (Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (Diagnostic Trouble Code Descriptions)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Verification
Verify that DTCs P0191, P0192, P0193, P025A, P0601, P0602, P0603, P0604, P0606, P062F, P0641, P06A6, P1255, P2534, or P2635 are not set in the FPCM.
If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (Diagnostic Trouble Code Descriptions).